ACM Aluminum Round Downspout Elbow 3 in. 75 Degree

This 3 in. aluminum round elbow changes downspout direction at a 75 degree angle, routing water away from the wall at the bottom of the run. It is sold as a single piece in six colors, including White 30 and White 80 finishes. Pair it with matching 3 in. round downspouts and outlets.

Key Features:

• 75 degree angle: Turns the downspout 75 degrees to direct water away from the foundation.
• 3 in. round style: Sized for 3 in. round downspout systems.
• Aluminum build: Made of aluminum for weather-resistant downspout service.
• Six color choices: Available in White 80, Copper Penny, Desert Sand, Linen, Terra Bronze and White 30.
• Sold per piece: Each elbow is ordered as a single piece for flexible job quantities.
• Lower-run use: Commonly used at the base of the downspout to kick water out at grade.

Specifications Table:

Fit and Compatibility:

Fits 3 in. round aluminum downspout systems. Use with matching round outlets, leader heads and downspout pipe in the same color. Note that round elbows do not fit rectangular 2 x 3 in. corrugated downspout systems.

Frequently Asked Questions (FAQ):

Q: What is included?
A: One 3 in. 75 degree aluminum round elbow per piece ordered.

Q: Will this fit my rectangular downspout?
A: No, this elbow is for 3 in. round downspouts; rectangular systems require a matching rectangular elbow.

Q: How many elbows does a typical install need?
A: Most runs use one or two: one to bring the downspout over at the bottom and, if needed, a second to angle it away from the wall.

Q: Is it color matched?
A: It is offered in six colors intended to coordinate with matching aluminum gutter and downspout components.

Q: How is it connected?
A: Elbows slip over or into the adjacent downspout section and are secured with sheet metal screws and sealed where a watertight joint is needed.

Expert Verdict Reviewed by the SuperArbor Pro Desk

A 75 degree elbow is the standard choice at the bottom of a downspout run because it kicks water farther out than a 45 degree elbow. Always seat the upper section inside the lower one so water sheds in the direction of flow, fasten with two sheet metal screws, and keep seams facing down. Match the elbow color to the downspout for a clean finished look.

Use fall protection and a stable ladder when working at the downspout, and wear gloves since cut aluminum edges are sharp.

Get the ACM 3 in. Aluminum Round 75 Degree Elbow in your color today.