FlashCo 10″ Heated Exhaust Flashing with 32″ x 30″ Large Base

The FlashCo 10″ Heated Exhaust Flashing is a large-base roof flashing sized 32 in. x 30 in., designed for heated exhaust penetrations. It is sold as a single piece. Use it with compatible FlashCo flashing system components on low-slope or pitched roof penetrations.

Key Features:

• Heated exhaust rated: Designed specifically for heated exhaust vent penetrations through the roof.
• Large base: Supplied with a 32 in. x 30 in. large base for broad coverage around the penetration.
• 10-inch size: Sized for 10-inch heated exhaust applications.
• Single piece: Sold as one complete flashing unit per piece.
• Light handling: Item weight is approximately 1 lb for easy handling on the roof.

Specifications Table:

Fit and Compatibility:

Intended for heated exhaust penetrations where a large 32 in. x 30 in. base is required; pair with FlashCo flashing accessories and sealants as specified by the roof system manufacturer. Confirm duct size matches the 10-inch designation.

Frequently Asked Questions (FAQ):

Q: What is included?
A: One complete 10-inch heated exhaust flashing with its 32 in. x 30 in. large base.

Q: What size penetration does it fit?
A: It is designated for 10-inch heated exhaust applications; confirm duct size before ordering.

Q: Why a large base?
A: The 32 in. x 30 in. base provides broad coverage around the penetration for membrane or shingle integration.

Q: How much does it weigh?
A: The item weight is listed at approximately 1 lb.

Q: Is it sold by the piece?
A: Yes, the selling unit is one piece.

Expert Verdict Reviewed by the SuperArbor Pro Desk

Heated exhaust penetrations run hotter than standard vents, so use flashings designated for that service rather than standard pipe boots. The large base gives you room to lap membrane or shingles correctly and seal the perimeter per the roof system manufacturer’s instructions. Verify the 10-inch size against the duct before ordering.

Follow the roofing manufacturer’s installation instructions and local code for heated exhaust penetrations; maintain required clearances from combustibles.

Get the FlashCo 10″ Heated Exhaust Flashing with 32″ x 30″ large base for your exhaust penetration.