Versico VersiGard EPDM Quick-Applied Termination Strip, 9 in. x 100 ft., Black

The Versico VersiGard Quick-Applied Termination Strip (QA RTS) is a 9-inch-wide, 100-foot-long black reinforced EPDM strip with pre-applied cured splice tape along both edges for membrane securement. This 45 mil strip bonds in place without wet adhesive for fast horizontal installation. Use it for membrane securement in the field of mechanically attached EPDM systems.

Key Features:

• Pre-applied tape: Nominal 30 mil (0.75 mm) cured EPDM splice tape adhesive is laminated along both edges of the strip.
• 45 mil membrane: Reinforced EPDM membrane strip is nominal 45 mil (1.1 mm) thick.
• Field securement: The 9 in QA RTS is used for membrane securement in the field of the roof on mechanically attached systems.
• Horizontal install: The 9 in width with tape on both edges is designed for horizontal installation only.
• 100 ft roll: Each unit is a 9 in x 100 ft length of termination strip.

Specifications Table:

Coverage & How Much You Need:

One unit covers approximately 100 linear feet of securement in a single strip, 9 in wide. The 6 in QA RTS covers the same length at walls, curbs and expansion joints where one taped edge is sufficient.

Fit and Compatibility:

Designed for Versico VersiGard EPDM single-ply roofing systems, including mechanically attached installations. The 6 in QA RTS variant (tape on one edge) suits perimeter securement at walls, curbs and expansion joints; both install on prepared EPDM membrane surfaces.

Frequently Asked Questions (FAQ):

Q: What is included in one unit?
A: One 9 in x 100 ft black QA RTS strip with pre-applied splice tape on both edges.

Q: How wide and thick is the strip?
A: The reinforced EPDM membrane is nominal 45 mil (1.1 mm) thick and 9 in (225 mm) total width; adhesive strips are 3 in (75 mm) wide.

Q: Where is the 9 in strip used versus the 6 in?
A: The 9 in strip secures membrane in the field of mechanically attached systems; the 6 in version adds perimeter securement at walls, curbs and expansion joints.

Q: How must it be installed?
A: The 9 in version with tape on both edges installs horizontally only; the 6 in version can run horizontally or vertically.

Q: Can it be applied in cold weather?
A: No, storage or use below 40 F (4 C) causes loss of adhesive tack.

Expert Verdict Reviewed by the SuperArbor Pro Desk

QA RTS replaces tape-and-primer termination details with a single peel-and-press operation, so keep surfaces clean, dry and primed per the membrane manufacturer’s requirements before pressing. Roll the strip firmly along both taped edges to achieve full contact. Reserve it for mechanically attached field securement and use the 6 in version at perimeters and curbs; never apply below 40 F.

Cut membrane and strip edges are sharp; wear gloves and keep primer and solvent away from ignition sources.

Order the Versico VersiGard EPDM 9 in x 100 ft Quick-Applied Termination Strip for fast field securement.